I just didn’t know this is was a thing, the device is a Pine II controller from Black Forest Motion, which should take 10–24V DC via USBC. Power bank is capable of 12V but doesn’t seem to want to negotiate.
Maybe it’s not running at 12v, but at 5v with higher current, which you can also do. The extreme example of this is the raspberry pi 5, which doesn’t have room for voltage regulation, so when it needs extra power, it tries to negotiate 5v at 5.3A (it’s a lot).
You can try using an app like “ampere”, but that will likely always read 5v because the phone reads the voltage after it’s gone through the regulator. You would need an usb tester to know what’s actually happening.
Depends on the decide and the power bank?? (why are we vagueposting?)
I just didn’t know this is was a thing, the device is a Pine II controller from Black Forest Motion, which should take 10–24V DC via USBC. Power bank is capable of 12V but doesn’t seem to want to negotiate.
Maybe your controller supports only 10 or 24 and not 12 🤷. I’m not sure if that’s a thing.
Nah it’s definitely flexible as it works fine with 12DC power brick, 3-4S LIPOs, just this issue with the USBC…
Maybe it’s not running at 12v, but at 5v with higher current, which you can also do. The extreme example of this is the raspberry pi 5, which doesn’t have room for voltage regulation, so when it needs extra power, it tries to negotiate 5v at 5.3A (it’s a lot).
You can try using an app like “ampere”, but that will likely always read 5v because the phone reads the voltage after it’s gone through the regulator. You would need an usb tester to know what’s actually happening.